Tiebacks >Colonial Revival Shutter Dogs

“Colonial Revival” explains a lot about the shutter hardware seen on many early homes.

The centennial celebration in 1876 was the first real recognition of historic structures in this country.  The Centennial was intended to showcase advances in American industrial technology to the world.  It was held in Philadelphia so Independence Hall & the Liberty Bell were proud attractions and received the appropriate facelifts. 

The “Fair” was a great success and probably marked one of the first times America recognized its historic structures as the national treasures they have always been.

The 1880’s saw the introduction of many new styles of shutter hardware, for the first time much of it based on earlier historic patterns.  Much of the hardware currently seen on historic buildings was produced and installed in that timeframe.  Our Southern cities are rich in hardware of this genre –  perhaps replacements for earlier hardware stripped and used to make cannons and such during the Civil War.

The sesquicentennial (150 years - 1932) celebration held again in Philadelphia was a technologic bust, but turned patriotic and spurred nationwide interest in Colonial architecture.  Much of the new construction in the following decades incorporated Colonial elements.  Shutters and their hardware are a hallmark of the style.

807 charleston shutter dog
810 sweet violet shutter dog

The Charleston™ #807
A semi-hand forged piece from the late 1800’s and very common in Charleston.  Based on an 18th century example in the same town.

6-1/2” high x 1-1/4” wide

Sweet Violet™ #810
I’ve seen this pattern on several properties built in the 1930’s.  It’s nice with some bulk for visibility while its rolled tail adds three dimensionality.  I see this piece as just right for bungalows.

6-1/2” high x 2” width

$34.00/pair
$36.00/pair
857 propeller shutter dog

The Propeller™ #857
Again, a semi-forged piece.  Stamped and rolled over the edge of the anvil.  Available in 5, 6 & 7” heights.  The smaller sizes common in Savannah.  Inspired by an earlier forging.

#857

5-1/2” x 1”  

$24.50/pair

#858

6-1/2” x 1-1/4” 

$26.00/pair

#859*

7-1/2” x 1-1/2” 

$18.00/pair

*  cut & bent only, not hand forged



 

 

 

 

 

 

 

 

 

 

Brandywine Forge Quick Find
SHUTTER TIE-BACKS
SHUTTER HARDWARE
HARDWARE 101
STANDARDS & FINISHES
Pre-Civil War Heavy Hinges Overview Overview Overview
1870's - 1920's Pintles Overview A Blacksmith's Glossary of Terms Standard Dimensions
1920's - Present Midweight shutter hinges & Pintles A Brief History of Early Hardware Weights of Material
Side-mount Shutter Dogs Lightweight Hinges Shutter & Hardware Terminology Finishes
Optional Mounts . . Tolerances
. . . .
SHUTTER LOCKS
GATE & HEAVY DOOR HARDWARE
HARDWARE SELECTION
INSTALLATION SITUATIONS
Overview Gate & Heavy Door Overview Overview
    Historic Restoration Hinges in Masonry
 
ORDERING INFORMATION
Visible Hardware Installation Options
  Overview Shutter Hardware Board & Batten Shutters
    New Construction Strap Hinges
      Window/ Door Location
      Window Flush
      Windows Recessed